The Milwaukee 4253-1 1/2 Inch Motor for Electromagnetic Drill Press features 6.2 amps and a 1/2" chuck turning at 600 rpm. This motor is best used on the 4202 fixed position base. Light weight and ample power make this a good choice for smaller holes into steel.
1/2 inch capacity, 6.2 amp motor, 600 RPM
1/2 inch keyed chuck
Taps up to 5/8 inch -18 threaded hole. 5/8-11 and 1/2-13 taps not recommended
Develops up to 1650 pounds of drill point pressure with a 1 inch steel plate
Voltage 120 AC Only
Amps 6.2
Drill Capacity 1/2"
No Load RPM 600
Chuck or Taper Chuck
Tap Capacity 5/8"-18
Drill Point Pressure 1,610/1,650 lbs
Tool Weight 8.0 lbs
Shipping Weight 9.7 lbs
No comments:
Post a Comment